SET YOUR CAR
FREE SHIPPING
On orders over $200
TALK TO A PARTS EXPERT
RALLYSPORT GUARANTEE
100% Money Back on Select Parts

Blouch Dominator 1.5XT-R 10cm^2 Ceramic Coated Turbo 3in Inlet

MODEL # BLCDOM1.5XT10CM3INCOAT

$1,800.00


  • Q: 3 in inlet  chris10 months ago

    What's the difference/ benefit to going with this turbo an getting a 3in inlet vs using the oem inlet sizing? Both seem to have same power rating. Better spool? Hold top end better?
    • 1 of 1 people found the following answer helpful

      A:  A larger turbo inlet would allow better flow and less turbulence. Which may result in better spool and power.

      Tylo R @ RallySport Direct
        
      Was this answer helpful?
  • Q: turbo blanket or cobb heat shield  LatinRacer822 years ago

    Hi. Do you recommend a turbo blanket and which one or just go with the cobb turbo heat shield?
    • 1 of 1 people found the following answer helpful

      A:  If you are choosing between one or the other, we would recommend a turbo blanket. The PTP turbo blanket (P/N FPRO35-009-07) would be a good choice.

      Karsten B. @ RallySport Direct 2 years ago  
        
      Was this answer helpful?
  • Q: Aftermarket TMIC vs Aftermarket FMIC  Brasso2 years ago

    Hey RSD, first of all, love the site and all that you do. Currently, only a Cobb SF intake and turboback are on my 2015 STI. I'm contemplating getting this turbo in combination with ID 1050X injectors, IAG fuel rails and lines, an AEM 320 pump, and TGV deletes. I know I'm right on the edge of needing something more than the stock TMIC. Would it be a waste to go aftermarket FMIC? Should I just go with an aftermarket TMIC? Could use some advice.
    • 0 of 0 people found the following answer helpful

      A:  I'd recommend Grimmspeed's TMIC for your setup. It flows more than enough air for this turbo, but would not come with the added lag that front mounts can cause.

      Marcus E. @ RallySport Direct 2 years ago  
        
      Was this answer helpful?
  • Q: oil feed line: WRX or STI?  zzyzx854 years ago

    Is the included feed line for WRX or STI? Is there a difference between the two?
    • 0 of 0 people found the following answer helpful

      A:  This feed line will work on some of the WRX's and STi's. If this turbo is confirmed for your car, the feed line will work.

      Chris W. @ RallySport Direct 4 years ago  
        
      Was this answer helpful?
  • Q: TGV deletes?  Mathias5 years ago

    Would this turbo install require TGV deletes?
    • 0 of 0 people found the following answer helpful

      A:  Most 3 inch turbo inlet hoses require TGV deletes, and whether deletes are required or not depends on which inlet hose you use.

      Zach G. @ RallySport Direct 5 years ago  
        
      Was this answer helpful?
  • Q: Spool time  Mathias5 years ago

    Between the 10cm and the 8cm, which would spool up quicker and have closer to stock spool characteristics?
    • 1 of 1 people found the following answer helpful

      A:  An 8cm housing will spool quicker because there is less volume for the exhaust to fill.

      Zach G. @ RallySport Direct 5 years ago  
        
      Was this answer helpful?