SET YOUR CAR
TALK TO A PARTS EXPERT
- Exhausts
- Cat Back Exhaust System
- Downpipes And Y-pipes
- Exhaust Headers And Manifolds
- Exhaust Gaskets And Hardware
- Axle Back Exhausts
- Shop All
- Engine Management
- Plug And Play Engine Management
- Staged Power Packages
- Engine Management Sensors
- Stand Alone Engine Management
- Engine Management Harnesses
- Shop All
- Air Induction
- Short Ram Air Intakes
- Turbo Inlet Hoses And Pipes
- Cold Air Intakes
- Air Intake And Maf Hoses
- High Flow Replacement Panel Filters
- Shop All
-
Q: Which side goes against the bolts? frank.4 months ago
I just got some crossmember transmission bushings and was wondering how they properly go on. One side is flat and one side has the circles slightly protruding. Which side faces the bolts and faces away? Or does it not matter?
-
-
0 of 0 people found the following answer helpful
A: The protruding circles will face each other and fit inside the holes on the transmission mount.
Karsten B. @ RallySport Direct 4 months agoWas this answer helpful?
-
0 of 0 people found the following answer helpful
-
Q: Automatic jroberts2 years ago
-
-
0 of 1 people found the following answer helpful
A: These are only confirmed for the Manual Transmission.
Brady R @ RallySport Direct 2 years agoWas this answer helpful?
-
0 of 1 people found the following answer helpful
-
Q: Will these fit? 4 years ago
-
-
0 of 1 people found the following answer helpful
A: These bushings will only work on manual transmission crossmembers because automatic crossmembers do not use bushings.
Zach G. @ RallySport Direct 4 years agoWas this answer helpful?
-
0 of 1 people found the following answer helpful
