SET YOUR CAR
TALK TO A PARTS EXPERT
- Exhausts
- Cat Back Exhaust System
- Downpipes And Y-pipes
- Exhaust Headers And Manifolds
- Exhaust Gaskets And Hardware
- Axle Back Exhausts
- Shop All
- Engine Management
- Plug And Play Engine Management
- Staged Power Packages
- Engine Management Sensors
- Stand Alone Engine Management
- Engine Management Harnesses
- Shop All
- Air Induction
- Short Ram Air Intakes
- Turbo Inlet Hoses And Pipes
- Cold Air Intakes
- Air Intake And Maf Hoses
- High Flow Replacement Panel Filters
- Shop All
Customer Photos and Videos
5out of
5stars
Tanner061391614
Bought this so my power steering pump would clear my FP 84mm Turbo inlet. First off this install SUCKS to do. I found it significantly easier to install the power steering line onto the fitting first on the rack side, then add the fitting onto the rack. Asode from that much better than OEM!
5out of
5stars
Mulky
The install was a pain but this wasn't the products fault it was just the nature of the install. Having a second person up top while you are under the car making it much easier. My leak was fixed for much lower price than OEM and the quality seems superior.
1 of 1 people found the following review helpful
5out of
5stars
Bugeyed
Easy install! IAG was kind enough to include an extra crush washer and viton seal in case you have to remove your power steering pump again.
5out of
5stars
Luccs
Good quality part, no issues when installing in by 2007 FXT SG9, and just keep an eye on the potential rubbing that the steel can do on other engine bay parts...
1 of 1 people found the following review helpful
4out of
5stars
03wagon
The fittings and line are very nice. Tightening the fitting on the rack side was a huge pain however. There was just not enough clearance to get the fitting on straight to tighten it. It would always seat at an awkward angle which would make it pop loose. After 3 hours of struggling, I finally finessed the line into a position that worked. All in all, the power steering leak I had was fixed and saved myself from buying a whole new rack that the shop recommended. Maybe the tolerance on my 03 WRX wagon is just an outlier, but I would not want to go though that install again.
4 of 4 people found the following review helpful
4out of
5stars
Farting Hello Kitty
Well built item that solved the leaking high pressure power steering line on my '05 WRX with 188k miles. It is a bit of a pain to install, and expect to get fluid on you. Now, the directions for the flat O-ring isn't clear in their instructions, so I had to call IAG. For anyone who plants to purchase this in the future, here are the steps: -remove FACTORY o-ring from rack side -stretch and install IAG FLAT o-ring onto the rack side -reinstall the FACTORY o-ring ON TOP of the IAG FLAT o-ring -install the rack to AN adapter
Product images
Community Media
