SET YOUR CAR
- Exhausts
- Cat Back Exhaust System
- Downpipes And Y-pipes
- Exhaust Headers And Manifolds
- Exhaust Gaskets And Hardware
- Axle Back Exhausts
- Shop All
- Engine Management
- Plug And Play Engine Management
- Staged Power Packages
- Engine Management Sensors
- Stand Alone Engine Management
- Engine Management Harnesses
- Shop All
- Air Induction
- Short Ram Air Intakes
- Turbo Inlet Hoses And Pipes
- Cold Air Intakes
- Air Intake And Maf Hoses
- High Flow Replacement Panel Filters
- Shop All
Product images
Product Media
Community Media
PERRIN Wing Stabilizer Black
Subaru STI 2015+
Product Resources
Features & Product Details
RallySport Direct carries a great selection of aftermarket performance products brought to you by PERRIN Performance.
These are the PERRIN Performance Wing Stabilizers and they have been designed to provide your rear spoiler with more structural rigidity to the deck of the wing to simply improve the downforce and aerodynamics. Additionally, they provide a more aggressive look to the exterior of your vehicle.
DETAILS:
NOTE:
Product Video
Specifications
Brand:
PERRIN
Color:
Black
Install Type:
Adhesive Tape
Installation Hardware Included:
Yes
Material:
Plastic
QTY:
1
Type:
Wing Stabilizer
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
PEOPLE WHO VIEWED THIS ITEM ALSO VIEWED
REVIEWS & CUSTOMER MEDIA
Customer Photos and Videos
5out of
5stars
Bomb 💣
These were a bit of a pain to put on. They dont sit flat so I had to double up the 3m tape at the bottom to fill in the gap. The tape kept rolling as I was continuously trying to readjust it in place. Other than that, the stiffies are absolutely beautiful. They complement the rear nicely makes my car look badass! I thought the plastic was thin and cheap but it is quite thick and great quality. Good investment🤝
3 of 4 people found the following review helpful
3out of
5stars
imout
The Perrin stabilizers are poorly designed, because they do not sit flat. I can see obvious gaps on the bottom. It did not matter how I positioned them, they would not sit flat on the trunk. I'm going to try heating them up, and trying to see if that helps them conform to the trunk. A second layer of the tape in the high spots would also help, but I can't do that without taking everything back off. I highly recommend using masking tape to mark the car when you have the stabilizers lined up. They move around very easily when you lift the wing, and will need constant readjustment without the tape. This will help you avoid a lot of frustration. As far as looks go, I think they look great. I just wished that they fit perfectly. I recommend thoroughly checking for gaps before taking the tape cover off. I
QUESTIONS & ANSWERS
No questions have been asked about this product.
