SET YOUR CAR
TALK TO A PARTS EXPERT
- Exhausts
- Cat Back Exhaust System
- Downpipes And Y-pipes
- Exhaust Headers And Manifolds
- Exhaust Gaskets And Hardware
- Axle Back Exhausts
- Shop All
- Engine Management
- Plug And Play Engine Management
- Staged Power Packages
- Engine Management Sensors
- Stand Alone Engine Management
- Engine Management Harnesses
- Shop All
- Air Induction
- Short Ram Air Intakes
- Turbo Inlet Hoses And Pipes
- Cold Air Intakes
- Air Intake And Maf Hoses
- High Flow Replacement Panel Filters
- Shop All
Product images
Product Media
Community Media
PERRIN Wing Stabilizer Black
Subaru STI Sedan 2011-2014
Features & Product Details
RallySport Direct carries a great selection of aftermarket performance products brought to you by PERRIN Performance.
These are the PERRIN Performance Wing Stabilizers and they have been designed to provide your rear spoiler with more structural rigidity to the deck of the wing to simply improve the downforce and aerodynamics. Additionally, they provide a more aggressive look to the exterior of your vehicle.
DETAILS:
NOTE:
Specifications
Brand:
PERRIN
Color:
Black
Install Type:
Adhesive Tape
Installation Hardware Included:
Yes
Material:
Plastic
QTY:
1
Type:
Wing Stabilizer
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
PEOPLE WHO VIEWED THIS ITEM ALSO VIEWED
REVIEWS & CUSTOMER MEDIA
Customer Photos and Videos
1out of
5stars
breezeupmykilt
I have had to remove these from my vehicle after two attempts to get a proper fit. The contour of the bottom of the stabilizer pulls up at the leading edge from the deck lid. There is about a 1/4 inch of the stabilizer extending off the the rear of the deck lid as well. Perrin needs to go back and complete the design work on these. Not happy with the product. The pictures are from 15 minutes after re-installation and the adhesive is starting to pull away from the deck lid.
4out of
5stars
2013slowsti
OK purchased three of these things and was a pain in the assignment to line up since you Fado want it symmetrical and centered. Went with three I do a lot of racing in autocross and road course. I noticed everything over 120mph and very worse at 145mph the wing just horribly bounces. With these stiffness installed my wing doesn't even shift at all and there is no more joining of my wing no more.
4out of
5stars
sabusoz2867971
I've been wanting these ever since I saw some on an 07 STI. So glad Perrin finally made some for the GR STI. Install was a bit tricky and the tape was a PITA (only reason for the 4 stars). I'd definitely recommend doing it with at least 2 people. They look amazing though and are very much worth the headache of getting them straight and dealing with the tape.
4out of
5stars
Printimus
These things are somewhat a PITA to install, especially since the 3m tape doesnt want to peel off like it should. But boy oh boy do they look good! Get 2 or 3!
QUESTIONS & ANSWERS
-
Q: wrx fitment? 09Jorge6 years ago
I have a 2009 WRX with the 2011 STI wing. Would these fit?
-
-
0 of
0 people found the
following answer helpful
A: Yes, as these are designed specifically for the STi wing.
Brady R @ RallySport Direct 6 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Do they hang off the back? sabusoz28679718 years ago
-
-
0 of
0 people found the
following answer helpful
A: If you space the stabilizers out much farther than the installed pictures below, then you will more than likely need to trim the base of the stabilizer so it does not hang over the edge of the trunk.
Zach G. @ RallySport Direct 8 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
