SET YOUR CAR
TALK TO A PARTS EXPERT
- Exhausts
- Cat Back Exhaust System
- Downpipes And Y-pipes
- Exhaust Headers And Manifolds
- Exhaust Gaskets And Hardware
- Axle Back Exhausts
- Shop All
- Engine Management
- Plug And Play Engine Management
- Staged Power Packages
- Engine Management Sensors
- Stand Alone Engine Management
- Engine Management Harnesses
- Shop All
- Air Induction
- Short Ram Air Intakes
- Turbo Inlet Hoses And Pipes
- Cold Air Intakes
- Air Intake And Maf Hoses
- High Flow Replacement Panel Filters
- Shop All
-
Q: Install location information richilg13 years ago
As stated in the single review above (and after googling), there really isn't any information on where to install this piece. The picture on Killer B's site is vague and doesn't seem to come with install instructions. I'm a DIY person, but I'd still like a little more info before I buy a pressure sensor gauge to use with this.
-
-
0 of
0 people found the
following answer helpful
A: There should be the port directly under the oil filter/oil cooler assembly where this would install.
Brady R @ RallySport Direct 3 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: npt or bspt? anarekist3 years ago
-
-
0 of
0 people found the
following answer helpful
A: All ports are 1/8BSPT, sorry for the confusion.
CodyWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Killer B Motorsport Dual Sender Adapter Fiesta ST Adapter4 years ago
-
-
0 of
0 people found the
following answer helpful
A: All ports are 1/8BSPT.
Katy Boyd @ Killer B Motorsport 4 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Does this fit the EJ257? aero6 years ago
-
-
0 of
1 people found the
following answer helpful
A: This will not work with the EJ series, this is only designed for the FA20. You can use this in direct function with a 1/8NPT fitting.
Jared A. @ RallySport Direct 6 years agoWas this answer helpful? -
1 of
1 people found the
following answer helpful
A: the killer b website says "Confirmed fitment on the EJ25" its just a splitter with all 1/8 npt threads (1 male and 2 female) however it was designed around the FA motor so i dont know how well this would fit under the alternator and perhaps might work better in the plug under the intercooler near the turbo. hope any of that helps!
Subaru_Kyle @Was this answer helpful?
-
0 of
1 people found the
following answer helpful
