- Exhausts
- Cat Back Exhaust System
- Downpipes And Y-pipes
- Exhaust Headers And Manifolds
- Exhaust Gaskets And Hardware
- Axle Back Exhausts
- Shop All
- Engine Management
- Plug And Play Engine Management
- Staged Power Packages
- Engine Management Sensors
- Stand Alone Engine Management
- Engine Management Harnesses
- Shop All
- Air Induction
- Short Ram Air Intakes
- Turbo Inlet Hoses And Pipes
- Cold Air Intakes
- Air Intake And Maf Hoses
- High Flow Replacement Panel Filters
- Shop All
-
Q: Fitment on JDM EJ20X JayTV10273 years ago
Will this fit on my JDM EJ20X with no fitment issues to the oil pan and long block?
-
-
0 of
0 people found the
following answer helpful
A: This will not fit the EJ20X because that engine came with a twin scroll turbo. The only header that we carry that would work would be Part #TOMTB6010-SB01A
Jesse F. @ RallySport Direct 3 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Fitment Gonza1lez3 years ago
-
-
0 of
0 people found the
following answer helpful
A: You bet, this will be a direct bolt on. Thanks.
Rick C. @ RallySport Direct 3 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: 2004 sti sl2young5 years ago
-
-
1 of
1 people found the
following answer helpful
A: Unfortunately, we would not be able to confirm fitment for 2004 and older model years of the STI.
Devan M. @ RallySport Direct 5 years agoWas this answer helpful?
-
1 of
1 people found the
following answer helpful
-
Q: Installation Jeff6 years ago
-
-
1 of
1 people found the
following answer helpful
A: You would also want to replace the head to manifold gaskets when installing these headers.
Evan M. @ RallySport Direct 6 years agoWas this answer helpful?
-
1 of
1 people found the
following answer helpful
-
Q: Diameter SubÉric7 years ago
-
-
1 of
1 people found the
following answer helpful
A: The inside diameter of both the header piping and up pipe will be 47mm.
Brady R @ RallySport Direct 7 years agoWas this answer helpful?
-
1 of
1 people found the
following answer helpful
-
Q: 2011 sti ggarcia_227 years ago
-
-
0 of
2 people found the
following answer helpful
A: Yes, this is a direct fit for your car. You will want the 2 bolt uppipe from Grimmspeed.
Josh P. @ RallySport Direct 7 years agoWas this answer helpful?
-
0 of
2 people found the
following answer helpful
-
Q: fitment! gallusa7117 years ago
-
-
1 of
2 people found the
following answer helpful
A: We are not able to confirm fitment with that oil pan.
Josh P. @ RallySport Direct 7 years agoWas this answer helpful?
-
1 of
2 people found the
following answer helpful
-
Q: Will I need a Subaru Oil Pan 11109AA151? JPLO8 years ago
-
-
0 of
0 people found the
following answer helpful
A: Usually if you have the 2.0ltr Ej20 motor it will require the oil pan.
guest566b370c2a8d25ff038ca65d @Was this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: shipping JPLO8 years ago
-
-
1 of
1 people found the
following answer helpful
A: 22lbs
Brady R. @ RallySport Direct 8 years agoWas this answer helpful?
-
1 of
1 people found the
following answer helpful
-
Q: 2011 STI apmiller08136218 years ago
-
-
0 of
0 people found the
following answer helpful
A: A 2011 STI comes with two O2 sensors from the factory; one in the header and one in the downpipe. This header will fit your 2011 STI.
Zach G. @ RallySport Direct 8 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: 2005 LGT wparker8 years ago
-
-
0 of
0 people found the
following answer helpful
A: Unfortunately we don't have a confirmed fitment on this product for a 2005 legacy GT 2.5.
guest566b370c2a8d25ff038ca65d @Was this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Fitment with greedy oil sandwich plate MrFreeze8 years ago
-
-
0 of
0 people found the
following answer helpful
A: We have not had any reported issues with a sandwich adapter but cannot guarantee it to fit depending on the thickness of the unit you have.
Nick S. @ RallySport Direct 8 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Tune? Dan Harper9 years ago
-
-
0 of
0 people found the
following answer helpful
A: A pro-tune is not needed, but its suggested to see the best results out of the header.
Kyle A. @ RallySport Direct 9 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: headers Miguelo9 years ago
-
-
0 of
0 people found the
following answer helpful
A: Yes, you will need an uppipe to connect to the turbo. You can either purchase a performance oriented uppipe which we offer or reuse your OEM factory uppipe. Thank you.
Sterling W. @ RallySport Direct 9 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Clearance Pspmskt205829 years ago
-
-
0 of
0 people found the
following answer helpful
A: You shouldn't have any issues with fitment on your car.
Kyle A. @ RallySport Direct 9 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Part number Wrxdude109 years ago
-
-
0 of
0 people found the
following answer helpful
A: Subaru OEM changes their part numbers for very small changes in products. We have it listed that the 11109AA131 is confirmed as an STI oil pan as well and should work fine, but we do not have the differences listed between the two.
Nick S. @ RallySport Direct 9 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: straight bolt on? cbr600rrjrd042259 years ago
-
-
0 of
0 people found the
following answer helpful
A: If you have a 2.0L WRX then you will require a new oil pan. For better assistance specific to your car please contact one of our Customer Service Representatives to get a much more accurate answer. As at this time we require additional information about your vehicle.
Kirill C. @ RallySport Direct 9 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Warranty aap19909 years ago
-
-
0 of
0 people found the
following answer helpful
A: Invidia states that using heat wrap will not void the manufacture warranty however ceramic coating will void the manufactures warranty.
Sterling W. @ RallySport Direct 9 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Gains SpcWoodall9 years ago
-
-
0 of
0 people found the
following answer helpful
A: Power gains will depend on your setup and the tune. On a car with the stock turbo you can expect anywhere from 10-40hp, depending on the tune.
Zach G. @ RallySport Direct 9 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Invidia Unequal Length? FearNoEvo_91910 years ago
-
-
0 of
0 people found the
following answer helpful
A: At this time Invidia does not offer an unequal length header.
Zach G. @ RallySport Direct 10 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: 2013 sti Bmwstep0094641910 years ago
-
-
0 of
0 people found the
following answer helpful
A: This will have a bung included for the stock sensor.
Kyle A. @ RallySport Direct 10 years agoWas this answer helpful? -
0 of
0 people found the
following answer helpful
A: The EGT sensor is only on older models that have catalytic converters in the uppipe and the sensor is in the uppipe, not the header. The bung in this header is for the stock O2 sensor.
Zach G. @ RallySport Direct 10 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Undertray jfrost915864410 years ago
-
-
0 of
0 people found the
following answer helpful
A: This header is compatible with the stock undertray.
Zach G. @ RallySport Direct 10 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Cobb AP T-WRX10 years ago
-
-
0 of
0 people found the
following answer helpful
A: Cobb does not have a map specific for a aftermarket header to be on the car. So at that point you would want to get a pro-tune for best results.
Kirill C. @ RallySport Direct 10 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Oil pan clearance? Dan-O10 years ago
-
-
0 of
0 people found the
following answer helpful
A: Yes this Invidia manifold will fit your 2011 STi with your stock oil pan. The oil pan on the 02-07 WRX and 04 STi are shaped differently and so this will not fit on those vehicles.
Tanner S. @ RallySport Direct 10 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Uppipe's? Subie drew 10 years ago
-
-
0 of
0 people found the
following answer helpful
A: Any up pipe that is able to bolt up to the stock header will work with this header. Invidia, Cobb, GrimmSpeed up pipes will all work.
Kirill C. @ RallySport Direct 10 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: 2012 sti hatch Ronin_STi10 years ago
-
-
0 of
0 people found the
following answer helpful
A: Yes this header will bolt up to your existing up pipe with no issues :)
Kirill C. @ RallySport Direct 10 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: wrx mattypbikes5904010 years ago
-
-
0 of
0 people found the
following answer helpful
A: Hello, This particular model will not fit wrx 02-07.
Kyle A. @ RallySport Direct 10 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Up pipe? thawu11 years ago
-
-
0 of
0 people found the
following answer helpful
A: Your stock uppipe should work but we strongly recommend investing in a new uppipe as well! Thanks.
Sterling W. @ RallySport Direct 11 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Tune? iBoost11 years ago
-
-
0 of
0 people found the
following answer helpful
A: Yes these will bolt up to the GS up pipe. And a pro-tune is not needed, but its suggested to see the best results out of the header.
Kirill C. @ RallySport Direct 11 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
-
Q: Difference? shapirotrevor8095611 years ago
-
-
0 of
0 people found the
following answer helpful
A: If you look at the two headers you will notice that the other NON big pipe unit features a very different piping routing and you will see that the primary runners on the passenger side are not combined at the same location. And would be similar to a long tube header.
Kirill C. @ RallySport Direct 11 years agoWas this answer helpful?
-
0 of
0 people found the
following answer helpful
