SET YOUR CAR
FREE SHIPPING
On orders over $100
TALK TO A PARTS EXPERT
RALLYSPORT GUARANTEE
100% Money Back on Select Parts

PERRIN Performance Front and Rear Endlink Kit

MODEL # PER1 PSP-SUS-113-213

$0.00


  • Q: Fitment  Steven6 months ago

    Installed both front an rear on my 02 2.5rs directions abit unclear. will they only be tightened on flat ground and not on jacks?I torqued on jacks then lowered to ground after checking alignment being hand tight did not need to lower to install bolts but With 2 extra washers in top (sway bar side) it doesnt exactly seem completely perpendicular or it won't?
    • 1 of 1 people found the following answer helpful

      A:  Yes, you need to torque these on the ground. The car needs to have load on it when you tighten them down so that everything will install properly.

      Devan M. @ RallySport Direct 6 months ago  
        
      Was this answer helpful?
  • Q: Fitment  Steven6 months ago

    Installed both front an rear on my 02 2.5rs directions abit unclear. will they only be tightened on flat ground and not on jacks?I torqued on jacks then lowered to ground after checking alignment being hand tight did not need to lower to install bolts but With 2 extra washers in top (sway bar side) it doesnt exactly seem completely perpendicular or it won't?
    • 1 of 1 people found the following answer helpful

      A:  Yes, you need to torque these on the ground. The car needs to have load on it when you tighten them down so that everything will install properly.

      Devan M. @ RallySport Direct 6 months ago  
        
      Was this answer helpful?
  • Q: Endlinks  Jtorio811 year ago

    Will this fit on a 06 foresters xt since it shares the same frame as the 02-07 wrx and will it fit with 24mm front /22mm rear sway bars
  • Q: Perrin Endlinks  GS2 years ago

    Is this kit compatible with a 2002 WRX Wagon? Thanks
    • 0 of 0 people found the following answer helpful

      A:  Yes, Perrin engineers their parts to work with both sedan and wagons for the GD chassis.

      Tyler A. @ RallySport Direct 2 years ago  
        
      Was this answer helpful?
    • 0 of 0 people found the following answer helpful

      A:  By looking at the front links that have the same ID for both ends, I'd say they're not. Thank you none the less.

      GS @
        
      Was this answer helpful?