SET YOUR CAR
TALK TO A PARTS EXPERT
- Exhausts
- Cat Back Exhaust System
- Downpipes And Y-pipes
- Exhaust Headers And Manifolds
- Exhaust Gaskets And Hardware
- Axle Back Exhausts
- Shop All
- Engine Management
- Plug And Play Engine Management
- Staged Power Packages
- Engine Management Sensors
- Stand Alone Engine Management
- Engine Management Harnesses
- Shop All
- Air Induction
- Short Ram Air Intakes
- Turbo Inlet Hoses And Pipes
- Cold Air Intakes
- Air Intake And Maf Hoses
- High Flow Replacement Panel Filters
- Shop All
Customer Photos and Videos
5out of
5stars
Cordsey
I would say definitely worth it to not have to press new backing plates in. It isn’t super noticeable in first bite with the 2 pot rears, but brake fade is substantially improved going from solid to vented rotors. If you drive hard, this is definitely an essential mod.
5out of
5stars
Baja
Yes. It worked just fine with my 05 baja. Pretty straight forward. Good quality part.
4out of
5stars
1stRSbuild
The quality of the parts was excellent. They appeared to be pretty hefty in structure. However, I did have some issue with the driver side holes not lining up. This was easily fixed with a little bit of reaming, took about 2 min. for that. A little locktite and torqued to 35 ft./lbs. Worked great! I believe they are a little overpriced for having to mess with the holes. The worst part is not having instructions and torque specs. I had to search on line for the info.
4out of
5stars
NuVision
Installed in my 2004 Forester XT. The passenger side gave me a bit of trouble. The holes would not align and the bolts would not go in straight. Use hand tools and don't force it. The drivers side went smooth with no issues. Overall solid product and highly recommend for a 4/2 pot swap.
3out of
5stars
slw2002wrx
Just got done putting these on my 2002 wrx wagon with 04 sti rotors and brembos. The brackets work. However, The holes where you bolt on the caliper are off just the slightest bit. I had to enlarge mine slightly on both brackets otherwise the bolts would cross thread. Kinda annoying considering i paid over 200 for em. Id recommend making sure they fit your brakes before trying to install them on the car.
3 of 3 people found the following review helpful
1out of
5stars
04fxt_josh
Installed these on a 2004 Forster XT and they are a absolute nightmare. The bold holes on the brackets don’t line up completely with the holes on the Forster knuckle. After a lot of bending and fitting they finally go on but will cross thread super easy. The bolts go in at an angle due to the holes not being lined up perfect. Poor quality for the $225 that you pay to get them.
Product images
Community Media
