SET YOUR CAR
FREE SHIPPING
On orders over $200
TALK TO A PARTS EXPERT
RALLYSPORT GUARANTEE
100% Money Back on Select Parts
Product images
Product Media
PERRIN Recirculating Blow Off Valve Red - Subaru WRX 2002-2007 / STI 2004+
PERRIN Recirculating Blow Off Valve Red - Subaru WRX 2002-2007 / STI 2004+
PERRIN Recirculating Blow Off Valve Red - Subaru WRX 2002-2007 / STI 2004+
PERRIN Recirculating Blow Off Valve Red - Subaru WRX 2002-2007 / STI 2004+
PERRIN Recirculating Blow Off Valve Red - Subaru WRX 2002-2007 / STI 2004+
PERRIN Recirculating Blow Off Valve Red - Subaru WRX 2002-2007 / STI 2004+
PERRIN Recirculating Blow Off Valve Red - Subaru WRX 2002-2007 / STI 2004+
Community Media
User Media for: PERRIN Recirculating Blow Off Valve Red - Subaru WRX 2002-2007 / STI 2004+
User Media for: PERRIN Recirculating Blow Off Valve Red - Subaru WRX 2002-2007 / STI 2004+
User Media for: PERRIN Recirculating Blow Off Valve Red - Subaru WRX 2002-2007 / STI 2004+

PERRIN Recirculating Blow Off Valve Red

Subaru WRX 2002-2007 / STI 2004+

Read 15 Reviews | 54 Q&As
Part # PSP-TAC-600RD
$199.80
msrp: $222.00

In stock!
Ships today if ordered in
9 hrs 4 mins

Features & Product Details

RallySport Direct carries a great selection of aftermarket performance products brought to you by PERRIN Performance. 

Here, you are looking at the PERRIN Performance Recirculating BOV. This blow-off valve features adjustable relief pressure and flow control to make fine-tuning on the fly simple and quick. 

 

DETAILS:

  • Cap, piston, and flange are CNC machined from 6061 billet aluminum materials
  • Blow off valve body is CNC machined from a single block of aluminum 
  • Anodized red finish
  • Large 1.225" inlets and outlets and is sized perfectly to relieve any amount of boost pressure without fear of compressor surge
  • Adjustable relief pressure with adjustable spring tension which allows for an adjustment when the blow-off valve vents
  • A looser setting will make it act smooth and more like stock while a harder setting will cause it to vent later and with significantly increased boost levels
  • Adjustable flow control allows you to control the volume of air released when the blow-off valve vents
  • Adjusting the volume of air helps maintain the perfect amount of boost in your system during shifts
  • Recirculating the air recirculates the air back to the intake track to maintain proper air-fuel ratio and driveability between shifts
  • Low maintenance and is quick and easy to disassemble
  • Direct fit and pre-set adjustment
  •  

     

    Specifications

    Brand: PERRIN
    Adjustable: Yes
    Color: Red
    Design: Piston
    OEM Replacement: Yes
    QTY: 1
    Valve Type: Recirculating
    Includes Gasket(s): No
    Mfgr. Warranty: 5 Years
    Condition: New Product
    Return Policy:

    RallySport Guarantee - 30 Days


    Items that are covered under the RallySport Guarantee offer a 30 day no questions asked return policy.

    RallySport Guarantee items may be returned within 30 days of the original invoice date and must include all the original parts and contents for a refund.

    The RallySport Guarantee does not apply to products that have been modified, damaged, misused or abused. All returns require an RMA (Return Merchandise Authorization) Number, and freight charges are strictly non-refundable. For more information regarding our freight refund policy, please refer to our return policy page found HERE.
    RallySport Guarantee
    WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

    PEOPLE WHO VIEWED THIS ITEM ALSO VIEWED

    REVIEWS & CUSTOMER MEDIA

    15 Reviews
    4.7 out of 5 Stars
    5 Stars
    (11)
    4 Stars
    (3)
    3 Stars
    (1)
    2 Stars
    (0)
    1 Stars
    (0)
    Customer Photos and Videos
    PERRIN Recirculating Blow Off Valve Red ( Part Number: PSP-TAC-600RD)
    PERRIN Recirculating Blow Off Valve Red ( Part Number: PSP-TAC-600RD)
    PERRIN Recirculating Blow Off Valve Red ( Part Number: PSP-TAC-600RD)
    1 of 3 people found the following review helpful
    Not as loud as expected  5 years ago
    4out of 5stars

    Great product but the noise is not a significant step up from factory BOV in my STI. Also with this product I'm developing turbo flutter at low rpm boost.
      
    Was this review helpful?
    0 of 1 people found the following review helpful
    Knarly sound! 5 years ago
    4out of 5stars

    At 100% atmosphere this thing makes a ruckus! It's nice that it is adjustable (in case you get sick of the noise). My one complaint is that you have to re-use part of the return for the old BOV. Not sure if this is because it is different on various vehicles, but it was a real pain to get off without damaging it..
      
    Was this review helpful?
    1 of 1 people found the following review helpful
    Be careful of those elbow SCREWS! 5 years ago
    3out of 5stars

    Purchased this and attempted to install on my 2009 STI. Had to reinstall my old recirc valve after attempting to remove the 2 SCREWS(yes, Subaru used 2 garbage quality screws to hold the return elbow to the recirc valve) to swap the elbow to the BOV. After using the correct crossed tip screwdriver with minimal effort, the screws stripped not allowing me to swap the elbow over. The quality of the BOV is excellent. A little over priced to be using recycled parts off my old recirc valve though. Recommend to install if your engine compartment is relatively new and clean with easy to remove hardware.
      
    Was this review helpful?
    1 of 1 people found the following review helpful
    Perfect 6 years ago
    5out of 5stars

    Took about 15 min. to install and another 10 to adjust. One word of advice is to take your time removing stock Philips head screws on elbow they are made of a soft metal and will strip easily.
      
    Was this review helpful?
    Great BOV 6 years ago
    5out of 5stars

    It looks badass in my 2005 sti. It works great, and preforms great too. Can handle a lot of pressure, and the sound is just what I was looking for. Fits perfect, and takes maybe 5 minutes to install. It comes with the new gasket, new bolts,and allen wrench which is a really nice. I love how its adjustable. I think that's such a good design. You can tune it to exactly what you want. No sound to loud and proud. I can't find any flaws in it, and I'm really picky when it comes to my sti. Its a little heavier than i was thinking, but well worth the money. Really strong and the black looks so nice.
      
    Was this review helpful?

    QUESTIONS & ANSWERS

    • Q: Recirculating BOV on a stock WRX STI 2017  Christian 5 months ago

      What spring tension setting will be best when running on stock internals?
      • 0 of 0 people found the following answer helpful

        A:  Honestly just leave it alone unless you've done something that is going to affect the vacuum the engine produces. Ie cams, headwork etc.. Thanks

        Rick C. @ RallySport Direct 5 months ago  
          
        Was this answer helpful?
    • Q: more mods  codemana1231518211 months ago

      will I need a retune after this part is installed?
      • 1 of 1 people found the following answer helpful

        A:  You should not need a tune if you're only installing a BOV on your car.

        Cody
          
        Was this answer helpful?
    • Q: Fitment  Jdominianni1 year ago

      Will this fit with a Perrin FMIC on a 2012 STi?
      • 0 of 0 people found the following answer helpful

        A:  It would depend on which flange is on the intercooler. If the flange matches up it would work great.

        Tylo R @ RallySport Direct
          
        Was this answer helpful?
    • Q: Front mount fitment  Sensiman842 years ago

      Is this part compatible with the Mishimoto front mount inter cooler?
      • 0 of 0 people found the following answer helpful

        A:  It would depend on which flange is on the intercooler. If the flange matches up it would work great.

        Devan M. @ RallySport Direct 2 years ago  
          
        Was this answer helpful?
      • 0 of 0 people found the following answer helpful

        A:  Yes because you have to use your stock BOV hose fitting and comes with mounting flange.

        nmlabonte
          
        Was this answer helpful?
    • Q: Fmic  Sensiman842 years ago

      Will this fit a front mount inter cooler setup? Maybe with an adaptor?
      • 0 of 0 people found the following answer helpful

        A:  It would depend on which flange is on the intercooler. If the flange matches up it would work great.

        Devan M. @ RallySport Direct 2 years ago  
          
        Was this answer helpful?

    This Part Fits