- Exhausts
- Cat Back Exhaust System
- Downpipes And Y-pipes
- Exhaust Headers And Manifolds
- Exhaust Gaskets And Hardware
- Axle Back Exhausts
- Shop All
- Engine Management
- Plug And Play Engine Management
- Staged Power Packages
- Engine Management Sensors
- Stand Alone Engine Management
- Engine Management Harnesses
- Shop All
- Air Induction
- Short Ram Air Intakes
- Turbo Inlet Hoses And Pipes
- Cold Air Intakes
- Air Intake And Maf Hoses
- High Flow Replacement Panel Filters
- Shop All
AEM Electronics Water/Methanol Injection Monitor System
Universal
Product Resources
Features & Product Details
RallySport Direct carries a great selection of performance products and accessories from AEM Electronics.
Here, you are looking at the AEM Electronics Water / Methanol Injection Monitor System and Failsafe Device. This is the most advanced water/methanol failsafe device on the market. It actively monitors the injection system’s ENTIRE flow curve to compensate for failure under ANY condition, allowing you to use your water/methanol system with complete peace of mind. If you have a water/methanol injection system or are considering one, you will not find a more advanced failsafe device on the market than the AEM Water/Methanol FAILSAFE Device.
Additionally, it actively monitors the entire flow curve independent of pressure, continuously collecting flow vs. injection rate data so that any deviation from your established flow curve will trigger an alarm output that can be used to reduce boost or timing, change maps, add fuel, trigger a two-step or perform practically any action you choose to save your engine. It is PC programmable (with USB connectivity) which eliminates the guesswork when setting min/max threshold parameters. It features PC-based software and an auto-scaling flow map that simplifies set up and has an “Auto Set” feature that will create a baseline configuration. A video showing its ease of set up is on www.aemelectronics.com. And it will work on virtually ANY water/methanol injection system that uses ¼” OD.
DETAILS:
Specifications
PEOPLE WHO VIEWED THIS ITEM ALSO VIEWED
REVIEWS & CUSTOMER MEDIA
My dad used to tell me all the time, The more extras it has, the more likely it is to have something fail. My kit did not work initially. After several firmware flashes and parts being exchanged, I discovered that the flow meter was assembled incorrectly from the factory. The customer support is good, so long as you don't work on your car on the weekends. The flow metering is good, and the software is easy to use. My AEM WM injection controller (V1) has started having issues now (about 2 months after installing the failsafe). While I don't blame the failsafe for the controller tripping up, it does not catch the fact that the WM Controller is messing up. So realistically, it is not functioning as a failsafe so much as just a flow meter. I had high hopes for this unit, but may convert to a different brand controller and failsafe because of the issues it has had. When it all works, it's great, but half the time when I start the car the failsafe or the controller will not be working. Usually it boils down to me having to shut the car off, wait 30 seconds and start it back up. As much as I love WM Injection and the flexibility it allows with tuning, I cannot recommend this particular product.
QUESTIONS & ANSWERS
This Part Fits
This item is non application specific.
Please verify compatibility before purchase. May require some modification for proper installation.
