SET YOUR CAR
TALK TO A PARTS EXPERT
- Exhausts
- Cat Back Exhaust System
- Downpipes And Y-pipes
- Exhaust Headers And Manifolds
- Exhaust Gaskets And Hardware
- Axle Back Exhausts
- Shop All
- Engine Management
- Plug And Play Engine Management
- Staged Power Packages
- Engine Management Sensors
- Stand Alone Engine Management
- Engine Management Harnesses
- Shop All
- Air Induction
- Short Ram Air Intakes
- Turbo Inlet Hoses And Pipes
- Cold Air Intakes
- Air Intake And Maf Hoses
- High Flow Replacement Panel Filters
- Shop All
Product images
Product Media
Community Media
Dialed Mounts Defroster Vent Mount
Subaru WRX / STI 2008-2014
Product Resources
Features & Product Details
RallySport Direct now carries Dial Mounts for those of you who are looking for an efficient means of mounting your automotive tuning accessories.
Here, you are looking at the Dialed Mounts Defroster Vent Mount. This mount has been designed to host the COBB Accessport and makes for a great alternative when compared to the double-sided sticky tape mount which is prone to failure or degradation over time.
DETAILS:
Specifications
Brand:
Dialed Mounts
Location:
Vent
Material:
Plastic
Type:
Mount
Mfgr. Warranty:
No Warranty
Condition:
New Product
Return Policy:
Standard
PEOPLE WHO VIEWED THIS ITEM ALSO VIEWED
REVIEWS & CUSTOMER MEDIA
Customer Photos and Videos
4out of
5stars
Bblack9066
The mount is super cool and easy to install. My only complaint is it shakes a lot while driving but its not bad enough for me to care too much. It might be my suspensions fault but I don't mind.
3out of
5stars
vricchetti2699500
Feels like a very rough 3D printed prototype of what could be a good product. The hardware is questionable - self locking nuts would make a lot more sense than your standard hex nut. The holes were a little different sizes as well, 1 bolt slid through and the other 2 had to be screwed/threaded into the plastic in order to fit. I’m in Arizona, I’ll be surprised if it holds up through the next 2 months with the heat. If you have a 3D printer, I’d say do it yourself.
4out of
5stars
[email protected]
So I have purchased this one as a curious it’s and wanted to make my interior feel like it’s almost oem fitment. Observing this product is clearly 3D printed. It’s not bad for what you paid for. Install is fairly easy. The only thing I don’t like about this is when you are driving around it shakes and it doesn’t matter if it’s bolted in tightly. So in my experience it should be a lil bit more sturdy without movement. But you get what you pay for.
QUESTIONS & ANSWERS
No questions have been asked about this product.
