FactionFab Front Brake Upgrade Kit

RallySport Direct proudly carries a great selection of high-performance braking components brought toy ou by FactionFab.

 

Here, you are looking at the FactionFab Brake Upgrade Kit. This kit includes new rotors, brake pads, and stainless steel brake lines to improve the braking performance of your vehicle. 

 

 

FRONT LOCATION

 

 

 

 

FACTIONFAB SWEPT SLOT BI-DIRECTIONAL ROTOR PAIR FRONT

Front location

Shallow Sharp-edged groves are milled into a high carbon cast iron disc to provide consistent pad contact and maximum friction over repetitive use

High-carbon content for wear resistance, thermal stability, and cracking resistance

Bi-directional design, meaning rotors are not side-specific

Symmetric vane castings to increase heat dissipation efficiency and thermal stability

Double-disc ground, non-directional finish

Mill balanced for reduced vibration

Precision machined with run-out spec of no more than .002", Disc Thickness Variation (DTV) of .0005"

Fully machined non-friction surfaces for perfect fitment

Sold as a pair

Electronically applied E-coating for corrosion resistance

400-hour salt spray tested

Fully coated inside and out

 

 

 

 

FACTIONFAB F-SPEC FRONT BRAKE PADS

Front location

Para-Aramid Composition

Ideal for auto-x, light track days, or aggressive street driving

1300ºF maximum operating temperature to aid in fade resistance

Excellent modulation and initial bite

Pre-scorched compound to aid in cold weather modulation

O.E. gas slots and chamfers ensuring for safe efficient stopping while reducing noise associated with vibration

Positive molded technology provides safe and reliable stopping performance for the entire service life of the brake pad

The positive molded technology manufacturing process uses extreme pressure to compress the friction material and drives out any impurities or excess resins found in the brake pad

Precision cut backing plates ensure correct pad fitment in the caliper body eliminating vibrations and noise under braking

Mechanically attached application-specific pad shims are designed to eliminate noise associated with brake pad vibrations

 

 

 

 

FACTIONFAB STAINLESS STEEL BRAKE LINES

Front location

PTFE Teflon inner liner to carry the fluid

Stainless steel woven middle layer for support of the inner liner

Abrasion-resistant, impact-resistant

Outer PCV clear abrasion resistant coating to aid in chaffing and protects the inner layers and stress relief at fitting locations

Each line is 4500psi burst pressure tested

Stainless steel precision machined fittings for perfect fit and corrosion resistance

Increased pedal feedback as a result of elimination of soft rubber lines which are prone to swelling and deforming

100% model specific for perfect fitment

Includes hardware