Bundle Savings:MSRP: $99.55
Free Shipping offer applies to orders over $200.00 to the 48 states via UPS Ground or USPS Priority. Offer Excludes shipments to Alaska, Hawaii and Military Boxes. Items that are too large to ship via UPS or USPS are excluded from this offer.Please read more on our full shipping policy View Shipping Policy
The kit contains 2 AeroCatches and stud strikes, all installation fasteners, rubber bump stops and bonnet cut-out template, and 2 Keys Specific for this Latch Set.
Available in Locking and Non-Locking Key designs. The pin can be inserted in the back, or the sides. This model is designed to sit on Top of the Body Panel.
AeroCatch recommends no more than a 5 degree angle between the pin and the latch.
RallySport Guarantee - 30 Days
Items that are covered under the RallySport Guarantee offer a 30 day no questions asked return policy.
RallySport Guarantee items may be returned within 30 days of the original invoice date and must include all the original parts and contents for a refund.
The RallySport Guarantee does not apply to products that have been modified, damaged, misused or abused. All returns require an RMA (Return Merchandise Authorization) Number, and freight charges are strictly non-refundable. For more information regarding our freight refund policy, please refer to our return policy page found HERE.
Take your time
Chandler B. 1 month ago
I can't stress it enough. Take your time and measure a lot. Install is tedious but doable.
2013 WRX Locking Hood Pins
@rob_wrexx 9 months ago
Very happy with these hood pins. I installed them on my Seibon carbon fiber hood and they not only look great but are a must have for carbon fiber hoods. Install was not as bad as i thought. I used my factory rubber hood stop location (one on each side just above the headlights) to install the pins instead of having to drill holes, then tightened them down with the supplied hardware. I then added a dab of grease to the top of the pins and set my hood down on them to mark the hood for the holes. I then drilled a hole just big enough for the pins to fit through and test fitted. Once the hole is drilled and the pins are sticking through the hood use template to mark out the hole for the top side of the hood for the latch itself. Make sure its perfect cause you can only cut once! I used a dremel with cutting wheel to cut the hole and it worked great. Once hole is cut out you can mount the latches with supplied hardware. Adjust pins to the right height so that your hood sits flush with your fenders and make sure to use provided rubber stops. Double check everything and you should be good to go!
loreniniraq11836 4 years ago
I had these put on my '04 STI with a CF hood. They look great and work perfect!
Culti 5 years ago
I had these put onto my '07 STi with the Seibon CW-II Carbon Fiber hood and they look insane! I really wish I went with the carbon fiber looking ones now to try and match my hood. The latching is awesome!
guest55c5367acaae52790b8e803c 6 years ago
I purchased these for my 04 STI and they are unbelieveable! I used the pre-drilled holes just a little inwards of the factory bump stops and it worked perfect. I went ahead and got the locking latches and did away with my factory hood latch. Not very hard to install just time consuming.
This item is non application specific.
Please verify compatibility before purchase. May require some modification for proper installation.